Ride-on Mower Services

Up To 42" Deck - £275.00 + Parts

Up To 50" Deck - £330.00 + Parts

4 Wheel Drive - £345.00 + Parts

✅ Steam Clean Tractor – Thoroughly washed to remove built-up dirt, mud, and debris.

✅ Steam Clean PGC Unit – Complete clean of the PGC unit for smooth operation.

✅ Check Engine Mounting Bolts – Ensure engine is secure and vibration-free.

✅ Check Exhaust System Mounting Bolts – Tighten to prevent leaks and maintain performance.

✅ Service Engine as per Manufacturer’s Schedule – Full OEM service for reliability.

✅ Check Starter Gear – Inspect for wear or damage.

✅ Check Throttle and Choke Control Operation – Adjust for smooth control response.

✅ Lubricate Throttle Linkages – Reduce wear and maintain smooth operation.

✅ Check Security of Gears and Linkages on Pedals – Ensure smooth, safe performance.

✅ Check Linkages and Pedals of Hydro Transmission – Inspect for free movement and proper function.

✅ Check Securing Bolts – Tighten for stability.

✅ Inspect Trans-Axle and PTO Belt – Check for wear, damage, or misalignment.

✅ Lubricate Gear Change Shafts, Pivots, and Links – Ensure smooth shifting.

✅ Remove Rear Wheels, Re-Grease Shaft, and Refit – Maintain smooth wheel rotation.

✅ Inspect Jockey Pulleys – Maintain proper belt tension and smooth operation.

✅ Check Front Axle for Free Play and Alignment – Adjust if needed for stable steering.

✅ Check Steering for Ease of Operation and Full Range – Ensure no stiffness or resistance.

✅ Lubricate Front Axle Centre Pivot – Reduce wear and keep steering smooth.

✅ Lubricate Steering Quadrant Centre Pivot – Maintain easy steering.

✅ Check Tyre Pressure Front and Rear – Adjust for optimal handling.

✅ Check All Steering Nuts and Bolts – Tighten for maximum safety.

✅ Check Steering Lock Stops – Prevent over-rotation.

✅ Check Front Wheel Bearings – Grease or adjust as required.

✅ Check and Clean Brake Unit – Adjust for safe braking.

✅ Check and Adjust Front Park Brakes – Ensure proper holding strength.

✅ Lubricate Brake Pedal Linkages and Clevis Pins – Maintain smooth operation.

✅ Check Brake Pad Condition – Replace if needed.

✅ Sharpen or Replace Cutter Blades – For a precise cut.

✅ Check Cutter Shaft Bearings and Housing – Prevent vibration.

✅ Check Pulley Alignments – Ensure smooth operation.

✅ Remove Cutter Deck and Inspect Blade Mounting Pans – Check for cracks or damage.

✅ Remove Gallery Top Cover, Inspect Internal Tooth Belt – Clean out debris.

✅ Check and Adjust Toothed Belt Location Bearing Clearances – Smooth operation.

✅ Check and Adjust Electric Clutch Air Gap – Maintain proper engagement.

✅ Check Electric Clutch Tie Bar Restraint Bolts – Tighten for safety.